Marigold Thank You Card
This project uses the Marigold - Printable Card Kit No.1 to create a vintage inspired thank-you card. This card was big hit at the Creative Diva - Girl’s Night Out in Tucson Arizona, held at the Melting Pot Restaurant.
Tools and Supplies
|
|
|
From the Marigold - Printable Card Kit, print the “Printable Card 01″ pdf page and cut out:
You also need one invitation sized envelope, or print and make the envelope provided in the kit. |
Other tool and supplies needed:
|
Step One:
Punch a hold in the middle of the Thank-You journal area, about 1/4″ from the top.
Also punch a hole in the card about 1/2″ from the top of the peach stamped frame.
Step Two:
Place Thank You paper over the front of the card and line up the two holes. Insert brad from the front and fasten it on the inside of the card.
Step Three:
Use your decorative scissors and cut around all four sides of the stamp to give it a stamp-like edge. While you have your scissors, you can also cut the edge the of envelope flap to match the stamp and give it a deckled edge.
Step Four:
Peel paper backing from foam square. Place foam square on the back of the stamp and then position stamp over the card and place to the left of the thank you area. Then you are finished!
